Differenze

Queste sono le differenze tra la revisione selezionata e la versione attuale della pagina.

--- vlsi:personalpages:cenna:links [21/03/2015 09:10]
cenna creata
+++ vlsi:personalpages:cenna:links [08/04/2015 17:30]
cenna cancellata
@@ Linea 18: / Linea 18: @@
 **Picosecond laser**\\
+Pulsed laser diode (3B class)\\
+Power: 1200 mW\\
+Wavelengths: 1064 nm, 405 nm\\
 Connection types: serial (RS232, USB-serial)\\
 Note: needs RS232 male-male cable (!), in case you don't have one, use USB connection. The connection can be displayed from Control Panel > System > Devices on your pc as UART (USB emulating serial) e.g. on COM3 port, then configure the serial connection as following:\\
@@ Linea 24: / Linea 27: @@
    * Stop bits: 1
    * End of command: carrier return \r (the instrument recognize the command only after carrier return)
    * Command list:
+                   state > display system status
+                   debug > display additional information
+                   ld=(0 disabled, 1 enabled) > enable/disable laser
+                   ld? > ask laser if enabled/disabled
+                   tune=(0 max, 1000 min) > set laser attenuation
+                   tune? > display laser attenuation
+                   te=(0 falling, 1 rising) > set trigger edge
+                   te? > display trigger edge
+Basic vi example to communicate with laser: {{:vlsi:personalpages:cenna:drivers:provacomandi.zip|}}
 Labview drivers: