Differenze
Queste sono le differenze tra la revisione selezionata e la versione attuale della pagina.
Entrambe le parti precedenti la revisione Revisione precedente Prossima revisione | Revisione precedente | ||
vlsi:analog_impedance_sim [23/04/2013 23:11] pacher |
— (versione attuale) | ||
---|---|---|---|
Linea 1: | Linea 1: | ||
- | ====== Node impedance simulation ====== | ||
- | |||
- | == Contents == | ||
- | |||
- | * Introduction | ||
- | * Procedure | ||
- | * Simulation example | ||
- | |||
- | **Keywords:** | ||
- | |||
- | |||
- | |||
- | ===== Introduction ===== | ||
- | |||
- | |||
- | ===== Procedure ===== | ||
- | |||
- | Basta attaccare un **idc** source al nodo di cui si vuole misurare l'impedenza di uscita e mettere AC=1. Poi analisi | ||
- | in frequenza e la tensione in Volt che mi esce e' anche il valore della resistenza in ohm (essendo R = V/I con I=1A) | ||
- | |||
- | apply a test current Iout | ||
- | and watch the effect on the output voltage (or vice versa). | ||
- | |||
- | Since Zout = Vout/Iout and Iout (ac) == 1, the magnitude of the output voltage corresponds indeed with the output impedance of your circuit. | ||
- | |||
- | In general you have to ensure that your device has the correct DC bias. The output resistance given by AC analysis is dependent on the bias. In general, you add a DC source (if needed for biasing) and then perform an AC analysis to get output impedance. | ||
- | |||
- | Place this source across the nodes where you want to measure the impedance. The Value attribute of the Current Source should be defined as 'AC 1'. This provides a 1A AC current source for AC analysis. Enter AC analysis. | ||
- | |||
- | Since the current is 1A, the voltage across the current source is equivalent to the impedance, so this expression will produce the impedance plot. | ||
- | |||
- | |||
- | |||
- | ===== Simulation example ===== | ||
- | |||
- | Esempio: diode connected NMOS | ||
- | |||
- | {{:vlsi:impedance_sim_schematic.png}} | ||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | {{:vlsi:impedance_sim_idc_settings.png}} | ||
- | |||
- | {{:vlsi:impedance_ade_settings.png}} | ||
- | |||
- | {{:vlsi:impedance_sim_dc_op.png}} | ||
- | |||
- | gm = 25.8 uS, gds <nowiki> << </nowiki> gm | ||
- | |||
- | 1/gm = 38.76 kohm | ||
- | |||
- | {{:vlsi:impedance_sim_ac_analysis.png}} | ||
- | |||
- | Vg = 38.76 kV poi su 1 A sono proprio 38.76 kΩ | ||
- | |||
- | |||
- | |||
- | |||
- | ====== ====== | ||
- | \\ | ||
- | ---- | ||
- | |||
- | Last update: [[pacher@NOSPAMto.infn.it|Luca Pacher]] - Apr 23, 2013 |